Cisco VPN Connection Issues from behind a cisco pix

[weinmatt]

I have two seperate clients setup on cisco pix501s.

One of the employees works for both companies and needs vpn access to the other site. I would rather not setup a point to point vpn between the two routers.

I am having trouble initiating the connection from behind the pix firewall. It just doesn't connect, no errors pop up. I have tested the connection successfuly from a connection not behind a firewall.

Is there a certain command I need to run to allow this? Are there certain ports I need to allow?

Thanks in advance!

 

[brianinms]

Make sure this command is in your configuration ...

sysopt connection permit-ipsec

 

[Supergrrover]

If you are using IPSEC - Check to make sure Nat traversal is enabled on both ends.

isakmp nat-traversal




Brent
Systems Engineer / Consultant
CCNP, CCSP

 

[boymarty24]

Have you checked the log at the client? If it doesnt connect to the remote pix check your access rules.