Hello all,
I am currently trying to place a PIX 506E firewall device between my Cisco 2600 series router, and my LAN. I am looking for debug commands that will help me follow packets from the LAN out to the internet, because I feel like I am close to making a successful installation. Here are the facts:
a) LAN is 10.0.0.x subnet, DMZ between router and PIX is 192.168.0.x subnet.
b) I can ping and telnet to the Cisco router from inside the LAN.
c) The PIX can ping internet addresses (tested google.com).
d) I cannot ping internet addresses from inside the LAN, even though all icmp traffic is allowed to pass through the PIX (only temporary for debug purposes).
Does anyone have any best practice debug info they'd like to share? It would be much appreciated.
Cheers,
-Cakestick
I am currently trying to place a PIX 506E firewall device between my Cisco 2600 series router, and my LAN. I am looking for debug commands that will help me follow packets from the LAN out to the internet, because I feel like I am close to making a successful installation. Here are the facts:
a) LAN is 10.0.0.x subnet, DMZ between router and PIX is 192.168.0.x subnet.
b) I can ping and telnet to the Cisco router from inside the LAN.
c) The PIX can ping internet addresses (tested google.com).
d) I cannot ping internet addresses from inside the LAN, even though all icmp traffic is allowed to pass through the PIX (only temporary for debug purposes).
Does anyone have any best practice debug info they'd like to share? It would be much appreciated.
Cheers,
-Cakestick
