Hi there,
I'm a bit new to this so I'll try to be as clear as I can.
We have just purchased a Cisco ASA 5505 Security Plus firewall. I have gone through the default settings foe setting up teh firewall with a default route of 0.0.0.0 going out of the Outside interface.
My problems comes when I enable WebVPN on the ouside interface I try to connect and get an error saying no route to the host.
I have setup two interfaces - Inside and Outside. The Inside int has NAT configured with some ACL's.
Any ideas ?
I'm a bit new to this so I'll try to be as clear as I can.
We have just purchased a Cisco ASA 5505 Security Plus firewall. I have gone through the default settings foe setting up teh firewall with a default route of 0.0.0.0 going out of the Outside interface.
My problems comes when I enable WebVPN on the ouside interface I try to connect and get an error saying no route to the host.
I have setup two interfaces - Inside and Outside. The Inside int has NAT configured with some ACL's.
Any ideas ?