Cisco 2900: Port Configuration 1

[flynbrian99]

Thanks vipergg...That worked great!

This is a Cisco 2916 and ports 1 and 2 do not light up when you plug into them...but 3-16 light up just fine...do you think this is a bad port issue or a config issue on these ports?

Thank you!

 

[vipergg]

"Do a show ip int brief and see if the ports are admin down , if so just do a no shut on the interfaces , other reboot the switch and watch thru the console port while it boots up , it will usually indicate a problem during POST if there is a problem with the ports.

 

[flynbrian99]

Thank you again!