cisco 2610 router configuration

[2610]

Hi
I am looking for the help to configure my two cisco 2610 routers
1) Router A - ethernet 0/0 connected to 172.20.0.0 network
- Serial 0/0 conneced to DSU 1 (V.35)

2) Router B - ethernet 0/0 connected to PC
- Serial 0/0 conneced to DSU 2 (V.35)
DSU 1 and DSU 2 are connected by permenent communication link

Thanks in advance.

2610

 

[bigdaddytim]

The easiest way to configure this is to use and unnumbered interface on the serial Port, using Unnumbered to the Ethernet port on this device. This can be used to automatically send packets to the Ethernet so that your Ethernet can be the Gateway. You still have to set the Clock rate on your serial port. Is your PC on the same subnet or is it a different subnet??