Cisco 2600 series 2

[tester125]

Hi I have a Cisco 2600 series router. Whenever I change any on the interface config and reboot I does not save the setting. I'm show there's a save setting area, unfortunately I'm new to Cisco.
Anyone knows where this sitting is that will allow me to save the information on the config so I don't lose it upon reboot

Thanks

 

[Parcival21]

try copy running-config startup-cunfig or just use the write comman(know it's an old command).

 

[lui3]

write memory or copy run start

also issue this command from #

show version

at the bottom there should be something refering to register configuration

make sure it is set to 0x2102

if not go into config mode and set it

router#config terminal
router(config)#config-register 0x2102
router(config)#exit
router#copy run start
router#reload

see if that helps

 

[tester125]

Sorry I did not get back to you guys earlier. The Write command did the trick.
Both of you guys gets a star.