CISCO 2600 Initial configuration

[bluedragon2]

Is there a way to get rid of the initial configuration question when booting the router?

Thanks



[Blue]Blue[/Blue] [Dragon]

If I wasn't Blue, I would just be a Dragon...

 

[fynx]

if "startup-config" doesnt exist in NVRAM you will get the initial config message.

simply copying the running-config to startup-config will stop the message appearing.

If everything is coming your way then you're in the wrong lane.

 

[bluedragon2]

Actually the startup was there, I found the answer:

The configuration register was set to 0x2142 and needs to be 0x2102



[Blue]Blue[/Blue] [Dragon]

If I wasn't Blue, I would just be a Dragon...

 

[JoeBloggssss]

Does it really piss you off that much! To amend the confreg

 

[bluedragon2]

Well, if it loses power and restarts, it will hang at the question until user intervention.



[Blue]Blue[/Blue] [Dragon]

If I wasn't Blue, I would just be a Dragon...

 

[plshlpme]

2142 is for password recovery.. it bypasses the nvram

 

[bluedragon2]

Thanks pls, I found that out later. I received these boxes from another division who had set it.

Thanks



[Blue]Blue[/Blue] [Dragon]

If I wasn't Blue, I would just be a Dragon...