Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cisco 2505 flash partitions 1

Status
Not open for further replies.
SeSe

SeSe

Programmer
Joined
Jun 8, 2001
Messages
32
Location
GB
Hi,
I have a 2505 with 2x4M Flash. The router sees only two partitions of 4M and I am unable to load my IOS 12.x image. Is there any way to concatenate the partitions so that 2505 sees them in one slice of 8M?
Thanks,
SS

 
Sort by date Sort by votes
Sure, you can do that... If the second partition has an image or anything on it, then you'll want to delete/erase that file so the second partition is blank. Then, from the config prompt, issue 'partition flash 1'... that should join the two partitions into one so that you can load an image.

Good luck.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Blackybear
  • Locked
  • Question Question
Cisco RV042G router
Replies
0
Views
321
Blackybear
Blackybear
B
  • Locked
  • Question Question
Cisco IP phone 7841 8851 unable to forward all to external number
Replies
0
Views
403
badwolf1686
B
pbxcomm
  • Locked
  • Question Question
CISCO VG450
Replies
1
Views
810
nt8d09
nt8d09
CPM86
  • Locked
  • Question Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
558
CPM86
CPM86
Skip Rango
  • Locked
  • Question Question
how to backup cisco sg500-52p switch
Replies
1
Views
798
madwok
madwok

Part and Inventory Search

Sponsor

Back
Top