cics 4.1 with flash 2

[fonegal]

cics 4.1 with a flash 2 2.1 also has a station expansion card. All of a sudden the flash went offline.Assumed flash went bad and took it to a repair facility and it works fine on their mirrowed cics.Took it back out and reconnected to the system and it still says (F983)not available,(F903) not
available,Checked station port with M7310 and works fine.
Flash is connected to station port 108.
Any Ideas??????

 

[luv2ski]

when flash plugged in what does port 108 say under maint port dn status

only thing i can think of is if xconn is being used with mod ends instead of line cord

6 months until ski season starts...sadly i must resign myself to the warmer weather"this will include a normal 8-5 work day, 5 days a week"

 

[fonegal]

port says unequipped until I plug in m7310.

 

[Phonehed]

Yeah that sounds like a connectivity issue. It may take several minutes to synch up and respond to your commands of course.

Phonehed in Dallas

 

[curlycord]

Try a 7208 to reset the ports.
Swap out mod cords
Try other ports

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[hawks]

Try the lower Feature codes and see what happens (F911, 912,913, ect)

 

[fonegal]

Ended up having to trash out programming on cics and completely reprogram.It appeared to be some sort of loss of timing between call pilot and cics.