Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CICS 4.1 IATA Dead?

Status
Not open for further replies.
daveinfla

daveinfla

Vendor
Aug 22, 2004
64
US

I'm only getting 2V on pair 20 am I missing something, like a prompt to enable the IATA?

It is listed at DN 27 P117 and it says its enabled and IDLE, but I'm only getting 2V!

Thanks,

Dave
 
Sort by date Sort by votes
What happens when you put your test set on pr 20 of the lines cable, you are on the lines cable, not the station cable.
 
Upvote 0 Downvote

According to the book the IATA is on pair 20 of the lines block, I've hooked an analog device up on a CICS before, but I've never seen an issue where it only had 2 volts and no dial tone.

I'm wondering if it's dead?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Locked
  • Question
CICS 4.1 date/time
Replies
6
Views
479
Firebird Scrambler
Firebird Scrambler
Mountainbear
  • Locked
  • Question
CICS Software versions
Replies
2
Views
414
curlycord
curlycord
MIKEY-MIKE7
  • Locked
  • Question
NORSTAR CICS 4X16 CALL FOWARDING OUTSIDE
Replies
2
Views
566
curlycord
curlycord
MIKEY-MIKE7
  • Locked
  • Question
Nortel CICS 4x16 Call foward Outside
Replies
3
Views
434
curlycord
curlycord
Stephen Smith
  • Locked
  • Question
Help Troubleshooting Nortel CICS Noise on all Phones - swap positions of trunk cards
Replies
2
Views
579
curlycord
curlycord

Part and Inventory Search

Sponsor

Back
Top