againwiththis
Programmer
Right now, local domain is "xxx.localdomain". I would like to change the suffix to match other customer domain naming scheme.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Changing domain name on BCM Call Pilot
- Thread starter againwiththis
- Start date
- Status
SupportDude
Technical User
- Thread starter
- #3
againwiththis
Programmer
Hello again SD.
BCM 4.0
This is in reference to the message networking/forwarding issue. FYI.
Thanks.
BCM 4.0
This is in reference to the message networking/forwarding issue. FYI.
Thanks.
SupportDude
Technical User
Hello!
If you're using a DNS in your Network, configure the BCM as a DNS proxy. Then when you configure your VPIM, the FQDN should show up as documented.
Go to the Configuration Tab.
Open the Data Services folder.
Highlight DNS to configure your settings.
-SD-
If you're using a DNS in your Network, configure the BCM as a DNS proxy. Then when you configure your VPIM, the FQDN should show up as documented.
Go to the Configuration Tab.
Open the Data Services folder.
Highlight DNS to configure your settings.
-SD-
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
