Changing DAC to an EXT in dialplan 1

[srmega41]

In my system, we had 7 and 8 set to be DAC with a lenght of 2. Not a very good use of numbers, so I changed the ones starting with 7 to 3 digits, and removed all the 8's. I now want to use 8 as an extension for things like hunt group members. When I try to change the dialplan, I get a message that some DAC are in use, and I have to remove them first. I get this, but when I do a list trunk-group TAC or list trunk-group-dac, all I get are the 7XX ones I already moved.

Is there another list or display command I am missing that will show me where the conflict is? I know it should be simple, yet I cannot find anything that conflicts with the change I am trying to make.

Thanks for the help,

Scott M.

 

[4merAvaya]

Check the loudspeaker paging access codes (display paging loudspeaker).

Kevin

 

[lopes1211]

Early systems had FAC and TAC. Later DAC was introduced which can be used in place of either FAC or TAC. Do a "display feature" and see if any of your codes are in there.

-CL

 

[srmega41]

Thanks, but no luck. That section is totally blank. Any other suggestions?

I appreciate the quick response Kevin!!!

Scott M.

 

[srmega41]

CL,

Nothing there either. All of those I checked earlier, and all or two digits staring with a # or a *.

Thanks to you as well,

Scott M.

 

[srmega41]

Just an update, the issue was a personal CO line. I was not even aware of these, and there was one that had a TAC of 85. Changed it to a 7XX number, and the dialplan changed without issue.

Thanks for the suggestions everyone. I guess this just proves I have a lot to learn on this system.

Scott M.