Changing Call Pilot IP back to default?

[MJSD333]

Hello,
Got a CP 100 with 3.0 software. The IP address has been changed to 192.168.1.200. I want to get it back to the default 192.168.110.10. I hooked up the serial connection and started a Hyper Terminal session. Booted the CP up and watched it spit the info into the session. I hit any key within 2 seconds and proceed to the section that shows the current IP address. I change it to the default,which I can only do outside the parentheses. How do I save this? Every time I try to access with laptop and crossover I can't get in. I do another hyper terminal session and it is still the 192.168.1.200 IP address.
Dmac,

 

[sprucegrover]

Can you not get in using the browser with the old IP?

 

[Justatec]

Hook up to it with x-over and or if you can get in with 192.168.1.200. Then just change it back to the one you want,it will boot up ..

 

[Justatec]

OR get in to it and go to reinstall,and reinstall ,

 

[silver987]

After changing ip you must reboot CP, just a thought you probably did that. Right?

http://www.silverlakecom.com

 

[MJSD333]

Hey Guys,
I'm such an idiot some times. I checked the FAQ's and found a post that has the steps on how to do it. Found it this morning and didn't have time to get back to you to let you know. It was submitted by Melissa Roberts. Worked like a charm.
Thanks,
Dmac,