Change calling Party number being sent out 3

[Trevatwork]

Hi

I have some sets that use copper cot route for outgoing calls, i have clba on the sets to block outgoing caller id

Can i have clba on the sets but setup a feature where i can use caller id from the clid table when i want to?


Thanks

Trevor

 

[bigindian65]

I think that has to be on the set and is not "on the fly" type deal. Thhe on the fly would be to *67 every call manually until you did want to send it

Mato' Was'aka

 

[Trevatwork]

Hi bigindian65

does this sound feasible? If so how do i add that flexible feature code?


I found this post thread798-1418177

and

The last reply says:

If the phone's COS is CLBA all CLID is blocked outgoing.
If you have release 23 or above, assign a CPPO Flexible Feature Code, make it *82. When you want to release the CLID block dial * 82, then whatever you dial for an outside line.

Thanks


Trevor

 

[bigindian65]

Sounds feazable to me, just opposite. I thought you was looking for something automatic w/o user intervention was my main thought.

Mato' Was'aka

 

[Trevatwork]

Hi bigindian

Could you please give me some info on where i would set this up, what loads etc, is it done on the set or is it system wide?


Thanks

Trevor

 

[bigindian65]

Ld 57 might already be in there, prt them out, or call out in town and test.

Mato' Was'aka

 

[Nortellian]

I am no expert but when using copper cot trunks I do not think you can control what information you send out using clid table. Clid tables are for PRI's because the D-channel on the PRI carries the information. COT's will either send out the number on the cot trunk or maybe the CO can send out one specific number.

 

[Trevatwork]

Hi guys

Thanks for the help

So I set cppo to *82 when i call out it gives the number i put on the clid table and the last 4 digits of main number.


Thanks again


Trevor