CDR Connection on Option 11C

[1000M]

I'm not that familiar with the Option 11C, I ned to connect a TTY port to a call buffer box for call accounting, where is this physical connection? And is it a 9 pin or 25 pin connector?

 

[johnpoole]

it's a db 9, and you'll need to build the tty in load 17..

john poole
bellsouth business
columbia,sc

 

[camaro67]

check and see if you have "cdr" in the customer data block set to yes , you will have to add the tty port number in the cdr data block

 

[vztech]

25 pin. Take the cab door off look below inside on left hand side you will see a cable coming out with 3 connections 0 , 1 and 2 I would use port 2.

in LD 17 youll need to make sure user is set to CTY,TRF.

if still not working check LD 15 and make sure CDR_Data is configured.

good luck

 

[1000M]

Thanks, I did already set up my Adan and also TTY port 2 for CDR. I just wasn't sure where the physical connection was, thanks eveyone....

 

[johnpoole]

your right, duh, that is a rj 21, 25 pin connector on the cable, another place to check is the routes, make sure that cdr is =to yes on each of the routes you need a report on. i don't add traffic to my dcr report, but if your software will translate it, it is a good tool

john poole
bellsouth business
columbia,sc