Can not open COM port in VFP6

[mshamz]

Hi,

I want to print some text on the COM port printer. When I run the following code it gives 'Invalid seek offset' error in VFP 6, while it runs fine in VFP 3.The code is as follows

MyHandel = fopen("COM4",12)

Can anybody help?

Thanx

Shamz
mshamz@hotmail.com

 

[DSummZZZ]

While I don't get that error using the example here or the other thread you posted, I do get a -1 for this example as I don't have a COM4. I am also using VFP6. Is there a reason you can't use the MSCOMM control?

Dave S.