Can I load balance with this 6500 setup?

[Morini]

Can anyone tell me what is the minimum IOS version I need to run a CSM module WS-X6066-SLB-APC, Software 3.1(6).

The 6500 Switch runs CatOS 8.3(3), with IOS on the MSFC2 version 12.1(8a)E5, there don't seem to be any load balancing commands available and I can't work it out. CSM loads OK, I can access it with the 'session' command.

Thank you!

 

[pplewis]

I got this off the Cisco website, might be helpful:
Q. How is the Catalyst 6500 CSM configured?

A. The CSM is configured with Cisco IOS and can run in a pure IOS chassis as well as a Hybrid chassis (running IOS with CatOS). The CSM does not operate in a pure CatOS chassis. Hybrid configurations require a minimum CSM version of 3.1(2) along with IOS version 12.1(13)E3 and CatOS 7.5.1. For a recommended version of IOS or IOS/CatOS combination for a specific version of CSM software, please refer to the CSM release notes.