Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MikeeOK on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Callmaster IV Settings 1

Status
Not open for further replies.

sozmena

MIS
Aug 22, 2002
73
TR
Hi all,
I have a CallMaster IV. From the time I off-hook and
get dialtone, I hear a beep every ~10 seconds.
When I try another CallMaster using the same line, there
is no beeps. So, I think that I have to change some
of its settings.
Any idea about this ?

Regards,

sozmena Share what u know, learn what u don't
 
Hello:

To stop the beeps, turn the set over -- you will find two dip switches. Make sure both of these are turned off.

This should stop your beeping problem.

Good luck!
 
Try this

ENABLING OR DISABLING THE RECORDER WARNING TONE
To enable or disable the warning tone on the recorder interface
1 While on-hook (the headset must be unplugged), press [ Select ]. The light next to [ Select ] goes on.
2 Press [ Mute ]. The CALLMASTER set is in option programming mode.
3 Dial the 2-digit code, "78" ("RT"). The current setting (Enabled or Disabled) is shown on the
display.
4 Dial [ * ] to change the setting.
5 When the setting you prefer is shown on the display, press [ # ] to save it and exit programming mode.

NOTE: No recorder warning tones will be produced when the Record Out Signal is disabled regardless of the setting of these tones.

OR

ENABLING OR DISABLING THE RECORD OUT SIGNAL
To enable or disable the Record Out Signal
1 While on-hook (the headset must be unplugged), press [ Select ]. The light next to [ Select ] goes on.
2 Press [ Mute ]. The CALLMASTER set is in option programming mode.
3 Dial the 2-digit code, "73" ("RE"). The current setting (Enabled or Disabled) is shown on the display.
4 Dial [ * ] to change the setting.
5 When the setting you prefer is shown on the display, press [ # ] to save it and exit programming mode.
NOTE: No recorder warning tones will be produced when the Record Out Signal is disabled.

VLG711
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top