Caller id number ..not name..

[Djarum]

This seems to be the reverse of all the other questions everbody else is asking, but it starts the same way as everybody elses post...
I got 2 new ISDN pri circuits and now.. I get name.
My call center uses number far more than name and I was wondering how to switch so the phones show number and not inbound cid name..
My cdr still outputs the inbound cid number so i know the switch is getting it, how do i display it to my end users.
If anyone has gotten name to work and remembers what they changed in their switch to get it to work, that would be helpfull

my tunk group looks like this

TRUNK GROUP

Group Number: 3 Group Type: isdn CDR Reports: y
Group Name: OUTSIDE CALL COR: 90 TN: 1 TAC: 193
Direction: two-way Outgoing Display? n
Dial Access? n Busy Threshold: 23 Night Service:
Queue Length: 0
Service Type: cbc Auth Code? n TestCall ITC: rest
Usage Alloc? n Far End Test Line No:
TestCall BCC: 4 TestCall Service:
TRUNK PARAMETERS
Codeset to Send Display: 7 Codeset to Send National IEs: 7
Max Message Size to Send: 260 Charge Advice: none
Supplementary Service Protocol: a Digit Handling (in/out): enbloc/enbloc

Trunk Hunt: cyclical
Digital Loss Group: 13
Calling Number - Delete: Insert: Numbering Format:
Bit Rate: 1200 Synchronization: async Duplex: full
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0



TRUNK FEATURES
ACA Assignment? n Measured: internal Wideband Support? n
Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: n Send Calling Number: y
Used for DCS? n
Suppress # Outpulsing? n Numbering Format: public
Outgoing Channel ID Encoding: preferred UUI IE Treatment: service-provider

Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: y


Send UCID? y
Send Codeset 6/7 LAI IE? y Ds1 Echo Cancellation? n

US NI Delayed Calling Name Update? n

Network (Japan) Needs Connect Before Disconnect? n

signaling looks like this
SIGNALING GROUP

Group Number: 3
Associated Signaling? y Max number of NCA TSC: 0
Primary D-Channel: 01B1624 Max number of CA TSC: 0
Trunk Group for NCA TSC:
Trunk Group for Channel Selection: 1
Supplementary Service Protocol: a



Any Ideas would be appreciated
Thanks

 

[lopes1211]

You don't have a calling number format on page 1. try "pub-unk"

-CL

 

[RTMCKEE]

Also our trunk groups are set to:
TRUNK PARAMETERS
Codeset to Send Display: 7 Codeset to Send National IEs: 7

"6" for both those entries. My Ts are in use so it wont let me change them to see if that makes the difference.

RTMCKEE

CM 2.1.1
Prologix R9.05
Modular Messaging 1.1

 

[Djarum]

Still having the issue,
thanks for the replies,
rtmckee my t1's were set to "6" yesterday and I changed them to "7" to try to fix it but still getting name.
Thanks again

 

[nohuhu]

Djarum,

unfortunately you don't have any control over incoming name/number. my suggestion is to contact your service provider and make him send you only number without the name.