Caller ID from site A to site B

[covcom]

Customer has a point to point T1 connecting site A to site B,They would like caller ID between the sites. I've been told this only possible with the point to point being a PRI.
I installed both systems about 2 months ago and everthing else is working fine.Here's what they have:
Site A:
mics, 7.0 xc, 1 6port combo, 1 6port exp
call pilot 150, vpn key codes installed and working
No trunk cards in ksu, left open for future PRI
3 ftm, 1 has the dti card in it. We pulled off 6 channels from the T1 for voice. 5 fsm
Site B:
mics, 7.0, 1 6port combo
1 dti card, 1 ls/ds for abound calls only, all inbound calls are transfered from site A
call pilot 100, vpn key codes installed and working

Lines used for the T1 are 061-067, unprovisioned 068-084
EM, pool C,ans mode auto, disa N

I have a the PRI key codes for future PRI, but have not installed it.
Target lines are assigned to all extentions, ring only
4 digit extentions
I've probably left out some important facts and will be happy to provide more info.

They only want the caller ID on Internal calls.
Thanks in advance
covcom

 

[hawks]

When you say VPN codes are you talking about MCDN because you will need them to connect the 2 as a private network.

 

[bwtc]

I asked a similar question quite awhile back, and was told that caller ID is not possible on an E&M.

 

[hawks]

He would need to change to a PRI circuit between the 2 sites.

 

[covcom]

Hawks
This is all pretty new to me, but I did use VPN, I was told
MCDN would network the 2 sites on 1 call pilot, with the VPN
I was able to create network mailboxes, at site A, I created a network mailbox for everyone at site B, and at site B create a network mailbox for everyone at site A. They are able to forward voicemails back and forth between sites.
This was a first for me, I was soooo happy.
One more cool feature, The employees use a back door number to call in to site A. You can enter an ext at site B and the call is transfered. This was an option on the call pilot 150, could not find it on call pilot 100.

Back to The caller ID issue:
Could I trick the system, Install the PRI key codes and program the lines for PRI???
Thanks
covcom

 

[hawks]

when you programm them as PR you need to use the SL1 protocol and that is what the MCDN gives you. Maybe someone out there has found a way around that.