cmcdan1523
Technical User
Has anyone looked at a way to allow the PBX to route calls to take place of regular calling cards.
Any ideas?
Any call detail issues?
Security?
Any ideas?
Any call detail issues?
Security?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Call Vectoring to route "calling card" calls
- Thread starter cmcdan1523
- Start date
- Status
I am not sure I completely understand your question, but we set up an 800 number to get into our switch, and it flows to a vector which prompts for a five digit extension. This was set up to get to our overseas center, but I enter a 5 digit remote access extension that is local to the switch. I then enter my barrier code and get switch dial tone. The remote access ext. is set up to allow external calling. I believe that trunk to trunk transfer is enabled to do this, which will raise security eyebrows. We monitor the remote access extension in CDR to keep tabs on its use.
- Status
Similar threads