Bridge LAT between 2x1600 routers

[maxcolmer25]

Hi,

could anyone please help me on an issue i have regarding LAT protocol. i need to bridge LAT from site A(main office) to site B(remote office). Both routers are connected via 128 serial leased line which connects Site B to the main office site A. I already have routing going on but have read that i can turn routers into bridges also. Does anyone have a sample config of this issue i could work off?
Any help on this would be greately appreciated.
Max

 

[BuckWeet]

to do bridging you need to go into your serial or bri interfaces and into the ethernet interface and do a command like "bridge group 1" 1 = variable.


Also do a command like "bridge 1 protocol ieee" 1 = variable again..

Also you can do a command like "bridge 1 bridge (protocol)" so that it will only bridge your LAT, and not IP, etc..


BuckWeet