BGP with NAT 1

[itspecial]

hi,

I am facing a problem combining the bandwidths I am being provided by two different ISP's. My router is a CISCO 2620, with 2 eth and 4 serial ports.

Any help in this will be appreciated..

Regards
Sriram

 

[buraglio]

I assume you want to load balance them? are they equal cost lines, like 2 full T1's? Do you want to accomplish redundancy? If you want redundancy and load balancing, you may want to use BGP. It's actually fairly easy to set up, depending on your situation.

http://www.netaxs.com/~freedman/bgp/bgp.html

is a good BGP doc, as well as

http://www.cisco.com/warp/public/459/18.html

and

http://www.cisco.com/warp/public/cc/pd/ibsw/mulb/prodlit/index.shtml

 

[itspecial]

hi,

thanks for the reply.

I would like to use both my bandwidth simultaneously.

From the first bandiwidth provider i am getting 512k, ( to be upgraded to 2MB soon )

From the second bandwidth i am getting 1MB ( to be upgraded to 2 MB soon )

Both these links are through OFC.

So even when one of my link goes down, i should be able to still use the net.

So can u tell me how do I go about this.

regards

Sriram