BCMSVu Wallboards not displaying correctly

[vvhitekid2]

I have BCMSVu 1.5 with some spectrum wallboards. I am not sure of the model number on those wallboards, but they are 2 lines, and about 5 feet.

My problem is that I when I run the BCMSVu software, and run the report, it looks fine in the software, but the wallboards are only using about half of the board's witdth.

Such a simple program, yet I can't seem where to make adjustments to the actual display of the wallboards... Any ideas? I think I may just be mising something silly.

 

[dmoore7648]

It has been a while since I have used BCMS but on the Wallboard setup screen (Server Side) you can select which model wallboard you have and it will customize the output signal for your type of wallboard.

D

 

[vvhitekid2]

Yeah.. i just NOW figured it out. I wasn't using 1.5, I was using version 1.1, and they didn't have an option for my wallboard size. All better now