GroundRatt
IS-IT--Management
Can anyone tell me where to get info on seting up reports in bcms? It shows it is enabled, but when i try to run a report it says no data in system...Thanks in advance
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
bcms
- Thread starter GroundRatt
- Start date
- Status
You need to turn on the measurements in the VDN's and Hunt Groups to start the process rolling.
Set the measurements to Internal and within the next hour interval you should start to receive information.
Test on the switch first by "List bcms..." command.
If data is there on the switch then the BCMSvu should grab it on its next download and you can then report on it.
Netcon1
P.S. There is also some parameters you can change on the second last page of the system features form to shorten the Interval time down from 1 hour to 1/2 hour.
Set the measurements to Internal and within the next hour interval you should start to receive information.
Test on the switch first by "List bcms..." command.
If data is there on the switch then the BCMSvu should grab it on its next download and you can then report on it.
Netcon1
P.S. There is also some parameters you can change on the second last page of the system features form to shorten the Interval time down from 1 hour to 1/2 hour.
charleshagen
IS-IT--Management
there is also a scheduler to have them automatically print these reports on a scheduled basis.
Charles Hagen
Charles Hagen
- Status
Similar threads
- Locked
- Question