Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BCC2 on a SX-200 ICP MX P.Node

Status
Not open for further replies.
TheMitelGuy

TheMitelGuy

IS-IT--Management
Joined
Mar 28, 2003
Messages
1,326
Location
CA
Has anyone seen the "wire bubbles" that are on the outside of the BCCIIs? They cause the card not to fit in the slot all the way. Am I suppose to remove them to get the card in?

Thanks
Neil
 
Sort by date Sort by votes
They are there to create a good ground connection for the card. don't remove them, but use a bit of effort to get the card in. These are the "bubbles" on the top and bottom of the card near the front.
 
Upvote 0 Downvote
Excellent, I rammed it in and were a go! Thanks.

(okay, I pushed it in a nicely as I could, but it's Mitel - it always works!)

Neil
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

syscon411
  • Locked
  • Question Question
SX-200 MX password
Replies
14
Views
1K
The mitel guy
The mitel guy
idahomitel
  • Question Question
SIP/PRI SX 200 ICP Dividing channels for different trunk groups
Replies
6
Views
278
idahomitel
idahomitel
P
  • Locked
  • Question Question
SX-200 MX random reboot "T1 ISDN removed/installed"
Replies
12
Views
993
Pipeline_50
P
idahomitel
  • Locked
  • Question Question
SX 200 ICP CFNA and xfer problems
Replies
18
Views
2K
The mitel guy
The mitel guy
idahomitel
  • Question Question
Assigning static ip address sx200 icp 5340
Replies
2
Views
163
idahomitel
idahomitel

Part and Inventory Search

Sponsor

Back
Top