AVAYA S8700 CM 2.x. T-1 to Nortel OPt 81

[glynnmsg]

we have a new office in NY which has a AVAYA S8700 CM 2.x. In Ct I have a option 81c running rel 25.40. We have just installed a T-1 (NOTE: not a pri) between the two sites for voice only. At this time on the nortel side I do not have QSIG. Can anyone help me out with the programming on the Nortel end ? And if you have any ideas on the AVAYA side that would be great. Thanks in advance

 

[halfatinotuna]

I too , would be very pleased if there was a responce to this question .

cheers

 

[bigbobbyc718]

I did this about 2 years ago between on Option 61C and a G3R. It was just a plain T-1 (Non PRI)

Nortel: Ld 17 Add the T-1 under CEQU
LD 16 Add route and make it a Tie for "TKTP"
LD 14 Add all 24 trunks

Avaya: Location: 02C11 Name: TIE TO S4 #2
Bit Rate: 1.544 Line Coding: ami-zcs
Line Compensation: 1 Framing Mode: d4
Signaling Mode: common-chan




Idle Code: 11111111
DMI-BOS? n




Slip Detection? n Near-end CSU Type: integrated






display trunk-group 86 Page 1 of 21
TRUNK GROUP

Group Number: 86 Group Type: tie CDR Reports: y
Group Name: OUTSIDE CALL-4 COR: 62 TN: 1 TAC: 786
Direction: two-way Outgoing Display? n Trunk Signaling Type:
Dial Access? y Busy Threshold: 99 Night Service:
Queue Length: 0 Incoming Destination:
Comm Type: avd Auth Code? n
Trunk Flash? n
BCC: 0
TRUNK PARAMETERS
Trunk Type (in/out): wink/wink Incoming Rotary Timeout(sec): 5
Outgoing Dial Type: tone Incoming Dial Type: tone
Wink Timer(msec): 300 Disconnect Timing(msec): 500
Digit Treatment: Digits:
Sig Bit Inversion: none
Analog Loss Group: 9 Digital Loss Group: 13
Incoming Dial Tone? y
Bit Rate: 1200 Synchronization: async Duplex: full
Disconnect Supervision - In? y Out? y
Answer Supervision Timeout: 10 Receive Answer Supervision? y

 

[halfatinotuna]

Many thanks BigbobbyC 718

 

[hawks]

Take a look at

http://www.tek-tips.com/viewthread.cfm?qid=1017219

it may help some.