Hello,
I referenced this forum for a long time and it has been a great resource. Now I need some help. We are getting ready to retire our 13 year old Avaya definity system. It will be replaced with a new Cisco system. We are running call CM 4.0 and Cisco will be call manager 11.5. I am trying to setup a H.323 link between the systems because we are not licensed for SIP. I have got everything configured following an older Avaya doc I found. Link At this time we can make calls from Avaya to Cisco and it works fine, but cannot call from Cisco to Avaya. When I try i get a few seconds of silence and then a fast busy. Debug logs on the Cisco show the packets leaving the going to the assigned Clan on the Avaya system. If monitor the configured Avaya trunk I see no activity at all. I ran a packet capture on the port and I can see the Cisco request a h.225 connection but it is never established. I have attached my trunk and signaling group config. I appreciate any help and input anyone can provide. Thanks
TRUNK GROUP
Group Number: 3 Group Type: isdn CDR Reports: y
Group Name: Cisco system COR: 1 TN: 1 TAC: 353
Direction: two-way Outgoing Display? y Carrier Medium: H.323
Dial Access? y Busy Threshold: 255 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n
Member Assignment Method: manual
Group Type: isdn
TRUNK PARAMETERS
Codeset to Send Display: 0 Codeset to Send National IEs: 6
Charge Advice: none
Supplementary Service Protocol: a Digit Handling (in/out): enbloc/enbloc
Digital Loss Group: 18
Incoming Calling Number - Delete: Insert: Format:
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0
RUNK FEATURES
ACA Assignment? n Measured: internal
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: private
UUI IE Treatment: service-provider
Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: y
Network Call Redirection: none Hold/Unhold Notifications? n
Send UUI IE? n Modify Tandem Calling Number? n
Send UCID? n
Send Codeset 6/7 LAI IE? n
TRUNK GROUP
Administered Members (min/max): 1/5
GROUP MEMBER ASSIGNMENTS Total Administered Members: 5
Port Name Night Sig Grp
1: T00116 5
2: T00117 5
3: T00118 5
4: T00119 5
5: T00120 5
6:
7:
8:
9:
10:
11:
12:
13:
14:
15:
SIGNALING GROUP
Group Number: 5 Group Type: h.323
Remote Office? n Max number of NCA TSC: 5
SBS? n Max number of CA TSC: 5
IP Video? n Trunk Group for NCA TSC:
Trunk Group for Channel Selection: 3
TSC Supplementary Service Protocol: a Network Call Transfer? n
T303 Timer(sec): 10
Near-end Node Name: CLan01b10 Far-end Node Name: CallManager
Near-end Listen Port: 1720 Far-end Listen Port: 1720
Far-end Network Region: 26
LRQ Required? n Calls Share IP Signaling Connection? y
RRQ Required? n
Media Encryption? n Bypass If IP Threshold Exceeded? n
H.235 Annex H Required? n
DTMF over IP: out-of-band Direct IP-IP Audio Connections? n
Link Loss Delay Timer(sec): 90 IP Audio Hairpinning? y
Enable Layer 3 Test? n Interworking Message: PROGress
DCP/Analog Bearer Capability: 3.1kHz
I referenced this forum for a long time and it has been a great resource. Now I need some help. We are getting ready to retire our 13 year old Avaya definity system. It will be replaced with a new Cisco system. We are running call CM 4.0 and Cisco will be call manager 11.5. I am trying to setup a H.323 link between the systems because we are not licensed for SIP. I have got everything configured following an older Avaya doc I found. Link At this time we can make calls from Avaya to Cisco and it works fine, but cannot call from Cisco to Avaya. When I try i get a few seconds of silence and then a fast busy. Debug logs on the Cisco show the packets leaving the going to the assigned Clan on the Avaya system. If monitor the configured Avaya trunk I see no activity at all. I ran a packet capture on the port and I can see the Cisco request a h.225 connection but it is never established. I have attached my trunk and signaling group config. I appreciate any help and input anyone can provide. Thanks
TRUNK GROUP
Group Number: 3 Group Type: isdn CDR Reports: y
Group Name: Cisco system COR: 1 TN: 1 TAC: 353
Direction: two-way Outgoing Display? y Carrier Medium: H.323
Dial Access? y Busy Threshold: 255 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n
Member Assignment Method: manual
Group Type: isdn
TRUNK PARAMETERS
Codeset to Send Display: 0 Codeset to Send National IEs: 6
Charge Advice: none
Supplementary Service Protocol: a Digit Handling (in/out): enbloc/enbloc
Digital Loss Group: 18
Incoming Calling Number - Delete: Insert: Format:
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0
RUNK FEATURES
ACA Assignment? n Measured: internal
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: private
UUI IE Treatment: service-provider
Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: y
Network Call Redirection: none Hold/Unhold Notifications? n
Send UUI IE? n Modify Tandem Calling Number? n
Send UCID? n
Send Codeset 6/7 LAI IE? n
TRUNK GROUP
Administered Members (min/max): 1/5
GROUP MEMBER ASSIGNMENTS Total Administered Members: 5
Port Name Night Sig Grp
1: T00116 5
2: T00117 5
3: T00118 5
4: T00119 5
5: T00120 5
6:
7:
8:
9:
10:
11:
12:
13:
14:
15:
SIGNALING GROUP
Group Number: 5 Group Type: h.323
Remote Office? n Max number of NCA TSC: 5
SBS? n Max number of CA TSC: 5
IP Video? n Trunk Group for NCA TSC:
Trunk Group for Channel Selection: 3
TSC Supplementary Service Protocol: a Network Call Transfer? n
T303 Timer(sec): 10
Near-end Node Name: CLan01b10 Far-end Node Name: CallManager
Near-end Listen Port: 1720 Far-end Listen Port: 1720
Far-end Network Region: 26
LRQ Required? n Calls Share IP Signaling Connection? y
RRQ Required? n
Media Encryption? n Bypass If IP Threshold Exceeded? n
H.235 Annex H Required? n
DTMF over IP: out-of-band Direct IP-IP Audio Connections? n
Link Loss Delay Timer(sec): 90 IP Audio Hairpinning? y
Enable Layer 3 Test? n Interworking Message: PROGress
DCP/Analog Bearer Capability: 3.1kHz
