Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Autobars Program
- Thread starter Stacyjo4
- Start date
Hi Stacyjo4,
What is this 'autobars' program? The only way I have done table uploads is with textfiles and a terminal program like Procomm over the years. With the NPA/NXX data changing so much anymore, I find it easier this way, since you can modify, update, or delete your textfiles to meet your requirements. If you are good at programming you probably could write your own routine for some of this type of work.
I am not awhere of any off-the-shelf type of software that does this.
Just a thought.......JIM......
What is this 'autobars' program? The only way I have done table uploads is with textfiles and a terminal program like Procomm over the years. With the NPA/NXX data changing so much anymore, I find it easier this way, since you can modify, update, or delete your textfiles to meet your requirements. If you are good at programming you probably could write your own routine for some of this type of work.
I am not awhere of any off-the-shelf type of software that does this.
Just a thought.......JIM......
- Thread starter
- #3
Hello there - The autobars program I have was designed by some Bell techs quite a while a ago. I am looking for the disk so I can find out exactly what type of program it was. I believe it ran in Reflections. It had pop ups that prompted you for the NXX RLI and NPA RLI and your area code, nxx ect. I have some scripts in procomm that I use, but I was looking for something a little more along the lines of what I had before.
Stacy
Stacy
- Status
Similar threads
- Locked
- Question
