tnjwinters
Programmer
I am trying to get an Analog Terminal Adapter to work on a 3900 series phone. I have made great progress, but still don't have dial tone and you can't talk or hear. Any help would be greatly appriciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
ATA Module 1
- Thread starter tnjwinters
- Start date
- Status
-
1
- #2
Have you programed the TN for the ATA?
It's 16 units higher than the set TN.
If set is TN 08 0 0 4, then ATA-TN is 08 0 0 20.
Needs cls= flxa vce and wta
and a key 0 scr xxxx (where xxxx is the DN)
Disconnect cord from set, plug it in the pwr-supply.
plug cord from pwr-supply into set.
LED on adapter should flash slowly if all is OK.
It's 16 units higher than the set TN.
If set is TN 08 0 0 4, then ATA-TN is 08 0 0 20.
Needs cls= flxa vce and wta
and a key 0 scr xxxx (where xxxx is the DN)
Disconnect cord from set, plug it in the pwr-supply.
plug cord from pwr-supply into set.
LED on adapter should flash slowly if all is OK.
- Thread starter
- #3
tnjwinters
Programmer
I have it programmed as a 3904 on TN 12 1 2 4 and 12 1 2 20. I can't get the 20 TN to take a CLS of WTA or VCE!
- Thread starter
- #4
tnjwinters
Programmer
Got it. I had to change CPTA to CPTD before it would take WTA and VCE. Thank you for the help. Tim
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question