namesrhard2pick
Technical User
I added an ATA 186 in call manager 4.2. When the device is connected to the network call manager is not seeing it. I used the MAC address on the label located on the device. Any idea?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
ATA 186
- Thread starter namesrhard2pick
- Start date
- Status
Iwontremember
IS-IT--Management
did you actually add it as an ATA or possibly add it as a phone by mistake?
Hope this helps.
Hope this helps.
- Thread starter
- #4
namesrhard2pick
Technical User
I found a couple issues.
1) The original switch port was not configured on my voice vlan.
2) The MAC address I entered manually had a typo.
Informational, when I plugged the device into a good port it actually auto registered, this is how I found the MAC typo. All I have to do now is manually adjust some of the settings and assign my DN.
1) The original switch port was not configured on my voice vlan.
2) The MAC address I entered manually had a typo.
Informational, when I plugged the device into a good port it actually auto registered, this is how I found the MAC typo. All I have to do now is manually adjust some of the settings and assign my DN.
- Status