Arcserve abend after NW6Sp3 1

[Drakujii]

Everytime I load astart (version 9) i get an abend after arcserve detects the HW. the process that abends is held by NWPA.NLM.

I tryied other version of the driver of my scsi card, every CA patch are installed, I even tryied to go back to the old NWPA.NLM file. nothing there

help
thanks

 

[deejay33]

My company had the exact same problem with the exact same setup. Our problem turned out to be a nlm conflict. Netware has a generic nlm for tape drives which is called NWTAPE.nlm. Arcserve comes with its own nlm fstape.nlm. They should not be used together. Try removing NWTAPE.NLM and then loading Arcserve.

DeeJay

 

[Drakujii]

ok thanks, I check what you said.
the only thing is that I changed the NWTAPE.CDM and not the .NLM

I've put a REM in front of load NWTAPE.CDM in the startup.ncf

Thanks alot

 

[KenB]

If NWTAPE.CDM exists in the C:\NWSERVER directory on the DOS partition it will be autoloaded when NWPA.NLM loads. You should rename this file or delete it. It also exists in C:\NWSERVER\DRIVERS but thats OK. If you load any *.ham drivers for SCSI or IDE you load NWPA.NLM automatically. Thats ok you need it.
I'm running NW6 sp3/Arcserve 9 and everything is fine with my server, no ABENDS.

HTH
Ken