Arcserve 9.01 E0007 Server is low on memory

[snorkel]

Hi. Netware 6.5 SP1A server running Arcserve 9.01 and CANWPABD (NOT NWASPI) and getting these errors. I have 1.5GB of RAM in the server (as reported at the system console by typing "memory").

Should I do any/all of the following to fix this problem???
1. Add "SET RESERVED BUFFERS BELOW 16MEG=300" to startup.ncf
2. Set "Minimum cache buffers required to start jobs" to less than 10%(current value) in the Arcserve Scheduler > Configure BrightStor Arcserve Server
3. Change BTI.cfg value of CacheSize=32768 to a lower value

Other suggestions??????

Thanks very much in advance.

 

[mugwup]

Having the same problem here. Server is netware 6.5 sp1 - 1GB memory - getting exact same error. Backups would run fine for 2 days then fail on the third. We are also running Inoculan 7 on the server. Have done the following:

1. Installed the most current patch from CA
2. Stopped Inoculan.

I can say since doing that we have had 3 days successful backups. Not sure yet if the patch fixed it or if it was stopping Inoculan. Am going to see if backup runs tonight - if so will start Inoculan on server and monitor. Will put result in this forum

 

[snorkel]

We are NOT running Inoculan so it takes that piece out of the loop for us. Does anyone have comments on my three possible solutions??