Arcserve 2000 Job Doesn't Run

[HolyWater]

Hi everyone. I had a tape loader go bad, and I got it repaired and rebuilt Arcserve. Now, jobs won't start. I noticed that if I set a job to run now and then restart the machine, it starts to back up. Then it never runs again like it should daily. Any idea why this happens or what to do?

 

[Cyklops]

Check on your 'Device Group Configuration'. Is this configured according to your scheduled backup jobs (ie. is the name of the group mentioned in the destination tab of the backup job the same as you configured ) and are all the slots visible from there ??

regards

 

[HolyWater]

I checked, and yes, it goes to the right place. The funny thing is, if I restart the machine, the back up starts, then I cannot end the job, and it won't continue to back up daily like it is set to.