Hi there . . .
I try to setup a single Win2k-SP3-Professional with 2 scsi cards and 2 Overland-Librarys.
One Scsi-Card is a Adaptec 2944 (Differencial) and the other one a Adaptec 29160 (normal
.
The Differencial-Library is a DLT-7000 with 15 Slot, the other is a 2 x DLT-8000 with 42 Slots.
If I use the "Device Configuration"-Tool, i set everything correct - like the hardware is build and connected.
But if I start Arcserve (and the Tapeengine), everything is messed up. . . will say . . .the wrong library has both DLT-8000 Drives, one Library (42 Slot) without any Drive assigned and the DLT-7000 has nothing assigned at all.
I have redone those steps already several times . . . but i does not work . . .
What's wrong ?
fRED
I try to setup a single Win2k-SP3-Professional with 2 scsi cards and 2 Overland-Librarys.
One Scsi-Card is a Adaptec 2944 (Differencial) and the other one a Adaptec 29160 (normal
.The Differencial-Library is a DLT-7000 with 15 Slot, the other is a 2 x DLT-8000 with 42 Slots.
If I use the "Device Configuration"-Tool, i set everything correct - like the hardware is build and connected.
But if I start Arcserve (and the Tapeengine), everything is messed up. . . will say . . .the wrong library has both DLT-8000 Drives, one Library (42 Slot) without any Drive assigned and the DLT-7000 has nothing assigned at all.
I have redone those steps already several times . . . but i does not work . . .
What's wrong ?
fRED