Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
AN Diag Mode
- Thread starter mccartha
- Start date
This is not too much of a problem, from the prompt type the following:-
bconfig config local <cr>
bconfig image local <cr>
boot <cr>
This basically tells the switch to boot from the arn.exe image file and a file named config (base config parameters)
stored on your flash card.
If these files are not stored on flash, you could try a directed netboot.
bconfig config local <cr>
bconfig image local <cr>
boot <cr>
This basically tells the switch to boot from the arn.exe image file and a file named config (base config parameters)
stored on your flash card.
If these files are not stored on flash, you could try a directed netboot.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question