Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Alphanumeric-dial-table 1
- Thread starter beshkey
- Start date
-
1
- #2
definityandcmuk
Technical User
- Dec 2, 2005
- 561
Alphanumeric Dialing enhances data-terminal dialing by allowing users to place data calls by
entering an alphanumeric name rather than a long string of numbers.
For example, a user could type 9+1-800-telefon instead of 9+1-800-835-3366 to make a call.
Users need to remember only the alpha-name of the far-end terminating point.
Alphanumeric Dialing allows you to change a mapped string (digit-dialing address) without
having to inform all users of a changed dial address. Users dial the alpha name.
When a user enters an alphanumeric name, the system converts the name to a sequence of
digits according to an alphanumeric-dialing table. If the entered name is not found in the table,
the system denies the call attempt and the user receives either an Invalid Address
message (DCP) or a Wrong Address message (ISDN-BRI).
Because data terminals access Communication Manager via DCP or ISDN-BRI data modules,
dialing procedures vary:
? For DCP, at the DIAL: prompt users type the alphanumeric name. Press Enter.
? For ISDN-BRI, at the CMD: prompt users type d, a space, and the alphanumeric name.
Press Enter.
More than one alphanumeric name can see the same digit string.
entering an alphanumeric name rather than a long string of numbers.
For example, a user could type 9+1-800-telefon instead of 9+1-800-835-3366 to make a call.
Users need to remember only the alpha-name of the far-end terminating point.
Alphanumeric Dialing allows you to change a mapped string (digit-dialing address) without
having to inform all users of a changed dial address. Users dial the alpha name.
When a user enters an alphanumeric name, the system converts the name to a sequence of
digits according to an alphanumeric-dialing table. If the entered name is not found in the table,
the system denies the call attempt and the user receives either an Invalid Address
message (DCP) or a Wrong Address message (ISDN-BRI).
Because data terminals access Communication Manager via DCP or ISDN-BRI data modules,
dialing procedures vary:
? For DCP, at the DIAL: prompt users type the alphanumeric name. Press Enter.
? For ISDN-BRI, at the CMD: prompt users type d, a space, and the alphanumeric name.
Press Enter.
More than one alphanumeric name can see the same digit string.
- Status
Similar threads
- Question