MattSavage
IS-IT--Management
Hello everyone.
I am trying to configure the firewall on a cisco 1760. I am doing this using SDM, and everything was fine until I deleted the rule allowing all IP traffic to pass from Fastethernet 0/0 to Ethernet 0/1. Now I have lost my connection through SDM and I must fix it using CLI. Since this is the first Cisco router I have ever configured, I have no idea how to do this. I would like to re-allow all traffic between the two ports. Can anyone help??
I am trying to configure the firewall on a cisco 1760. I am doing this using SDM, and everything was fine until I deleted the rule allowing all IP traffic to pass from Fastethernet 0/0 to Ethernet 0/1. Now I have lost my connection through SDM and I must fix it using CLI. Since this is the first Cisco router I have ever configured, I have no idea how to do this. I would like to re-allow all traffic between the two ports. Can anyone help??