ItIsHardToProgram
Technical User
I was wondering if there was a way to transfer EVERY single DWG object through tables in Access without having to add them... I doubt it is possible but still would like to know...
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
ADODB to Autocad....
- Thread starter ItIsHardToProgram
- Start date
- Status
TCARPENTER
Programmer
Hi ItIsHardToProgram
Can you be a little more specific "...without having to add them..." what exactly do you mean?
Todd
Can you be a little more specific "...without having to add them..." what exactly do you mean?
Todd
- Thread starter
- #3
ItIsHardToProgram
Technical User
Manually right down the item in a table...
TCARPENTER
Programmer
Hi ItIsHardToProgram,
Okay, I'm still confused...
You have an existing drawing with lines, arcs, etc. You want to query the drawing, and transfer what exactly, line start and end points, arc start and end points, block insertion points, attribute values etc.?
If this is what you're after the short answer is yes it can be done. Depending on what exactly you want out of the drawing and how your drawings are set up may be another issue.
HTH
Todd
Okay, I'm still confused...
You have an existing drawing with lines, arcs, etc. You want to query the drawing, and transfer what exactly, line start and end points, arc start and end points, block insertion points, attribute values etc.?
If this is what you're after the short answer is yes it can be done. Depending on what exactly you want out of the drawing and how your drawings are set up may be another issue.
HTH
Todd
- Status