Adding PRI

[Justatec]

I have ip office v2 500 R7, Question is i have 9 analog lines in it at this time, And i am told they are looking to add two PRI'S to it, first Can i plug them into slots 3 and 4 does it matter, And then do the programing to get the PRI's going and then cut over to thePRI. Or do they have to be in slot 1 of the cabinet..thanks

 

[CarGoSki]

The slots of that chassis can accommodate the cards of your choice in the order of your choice except the expansion card.

 

[Justatec]

Thanks, Wasn't sure, I have installed 6 so far and only 1 with a PRI in it, So next question is can i fire up the PRI and get it programed and then cut it over,,Or doesit all have to be dont at once. Just want to know if i need all ducks in a row first which is a good thing of course but some tele'o are a pain... thank's

 

[ConXtion]

You should be good to go with performing the 'former' rather than the 'later'. It's good to have your ducks in a row, but in this case it dosn't have to be done all at once.

R.A.F.
Communications Solutions, Inc


We are what we repeatedly do; therefore, excellence is not an act but a habit - Aristotle

If a man does his best, what else is there? - General George S. Patton

 

[CarGoSki]

Best to get the hardware installed and operational first but sometimes the bean counters would prefer to roll the dice.