Adding Another Paging Zone????

[rtetryyt]

We currently have a paging zone in one department. We are in the process of having another paging amp put in for another department. I printed off what we currently have below. All I want to do is duplicate it. What steps would I take? And how do I find available Trunk ports?
Thanks TJ


TYPE: rdb
CUST 0
ROUT 82

SCH0858

ROUT
ACOD 82

TYPE RDB
CUST 00
DMOD
ROUT 30
DES IMPAG
TKTP COT
NPID_TBL_NUM 0
PRIV NO
SAT NO
RCLS EXT
VTRK NO
DTRK NO
ISDN NO
PTYP ACO
AUTO NO
ICOG OGT
RANX NO
SRCH LIN
STEP
ACOD 82
CPP NO
TARG
CLEN 1
OABS
TIMR ICF 512
OGF 512
EOD 13952
DSI 34944
NRD 10112
DDL 70
OOD 1
ODT 4096
RGV 640
FLH 510
GRD 896
SFB 3
CRD 512

IENB 5
TFD 0
LEXT 100
VGD 6
SST 3 0
NEDC ETH
FEDC ORG
CPDC NO
SPCT IMM
HOLD 02 02 40
SEIZ 02 02
RGFL 02 02
RVSD 08 31
ILLR 02 02
CDR NO
MUS NO
MR NO
MANO NO
EQAR NO
FRL 0 0
FRL 1 0
FRL 2 0
FRL 3 0
FRL 4 0
FRL 5 0


PAGE 002

FRL 6 0
FRL 7 0
OHQ NO
OHQT 00
TTBL 0
ATAN NO
OHTD NO
PLEV 2
MCTS NO
ALRM NO
ART 0
SGRP 0
AACR NO

 

[trvlr1]

Go to LD 21
LTM
82
This will show you the trunk that connects to the paging system. A stat of that card in LD 32 will show you all the ports on the card and tell you if you have a spare. Copy everything except the ACOD and you should be good. I assume you dial 82 for this paging access, ACOD is what does this. you might want to use 82 if available.

 

[DGJimmy]

Actually you will want to do a LTM for route 30 not 82. Are you adding another Zone or adding another Amp for a different area?

 

[rtetryyt]

Another Zone. Thanks!

 

[rtetryyt]

What load do you go to to actually add the new Route? Do you type NEW?

 

[trvlr1]

sorry yes, rt 30, I looked at the top where the number was entered incorrectly ....duh!