Adding a new "network" (topology)

[JPBZ28]

Any help greatly appreciated. I recently added a new subnet; xxx.xxx.4.x, we currently have 1, 2, and 3 also. The routers have been configured, everythig works fine, but I cannot add the 4.x network properly in Checkpoint FW-1 NG. I added the network, exactly as the other three are setup, I added the network to the "internal networks group", but when I go to do the topology, the new network does not show up, only the three existing. Any ideas?

 

[ChrisAC]

Do you mean that the new network is configured on the firewall, ie. you have configured an interface on the firewall with an xxx.xxx.4.xxx address?

Chris.


**********************
Chris Andrew, CCNA, CCSA
chris@iproute.co.uk
**********************