add D1000 to a Enterprise II

[kouchpotato]

Hello,

I am attempting to connect a d1000 with 12 disks to a Sun Enterprise II.
Have connected it up to a ultra wide scsi card and am using ultrawide cables.
when I do a probe-scsi-all from the OBP the server is unable to see the disks in the d1000.
The server had previously had a d1000 connected but has since been reformatted.
Have I missed something along the way?
thanks

Mat

 

[tuka]

You stated the server had a D1000 installed on it earlier so you must be using the same DIFF controller. Are you sure the D1000 has a DIFF terminator attached.

 

[kouchpotato]

we are using a different terminator than we had used previously. Will swap the terminator with our other d1000 and see if we get any joy.
M

 

[kouchpotato]

cheers tuka,
you were right - the terminator was incorrect..
thanks again
M