ACOD for Paging route over tie lines

[tech32001]

I'm trying to dial the ACOD of a paging route from one site to another over tie lines. The tie lines have a D- channel. There are no tgar's or targ's involved, ncos and frl's are fine. I tried an acd queue ncfw to acod, fast busy. Tried fdn on an analog tn, continues ring. These are sent via DSC. I also tried TSC. Any ideas ?

 

[johnpoole]

sounds like you have tried everything so it must work? is the ncos of the inbound trunk matched to the ncos of the page route? i would use the dsc plus delete 4 and add the acod// another thing to try would be a number you can normally dial between the two then build a new idc table in 49 and put it on the tie route,, the only way i usually block trunk to trunk access via acod is tgar/targ.. you've check that and delete the default 1, are you using opt cff or cfo? that could be your block

john poole
bellsouth business
columbia,sc

 

[tech32001]

Hey guys. Thanks for your input on this. It turns out I needed a feature package #307, Call Page Network Wide. You get a prompt in the RDB, NACC. It's specifically for accessing paging over a tie route.

 

[johnpoole]

couple of other ways to do that, i've got it working without the package but, my remote site has a unique acod and does not get all page

john poole
bellsouth business
columbia,sc