-
1
- #1
SuperTanker
IS-IT--Management
Issue: Abbreviate dialing number strings started w/11. We wanted it to start with 01.
Type disp sys cu(Display System parameters customer-options) check for:
- abbr dial enh list set to y
- A/D G/S list start at 01 set to y
NOTE If you leave the A/D line set to N only the system speed dials will begin at 01, not group speed dials which may be useful.
Type cha abbr sys cursor will be at the size field. Change the number to 100. This will provide the max number of system speed dials and allow for positions 01-10 to be used.
NOTE Once complete your system will still display the abbr dial numbers starting at 11. You can however hit pg up to see 01-10.
NOTE Changes to these numbers are made in the same way as you would normally change any other abbr dial number.
Type disp sys cu(Display System parameters customer-options) check for:
- abbr dial enh list set to y
- A/D G/S list start at 01 set to y
NOTE If you leave the A/D line set to N only the system speed dials will begin at 01, not group speed dials which may be useful.
Type cha abbr sys cursor will be at the size field. Change the number to 100. This will provide the max number of system speed dials and allow for positions 01-10 to be used.
NOTE Once complete your system will still display the abbr dial numbers starting at 11. You can however hit pg up to see 01-10.
NOTE Changes to these numbers are made in the same way as you would normally change any other abbr dial number.