3725 Cordlesss Phone

[KPM2S]

Hey Guys,

So I have a customer who has a 3725 cordless phone and the caller ID doesn't show for external calls. During some reading and investigating I have read that there is a difference between Provisioned and Non-provisioned and that the Provisioned works best. Does anyone know what the difference is and is it easy to change between the 2 types? Its an IPO v2 running 8.1_95. The handset and antenna both have the latest firmware and boot software.

 

[intrigrant]

Provisioned has as advantage that it will show the status of the user with the status letters as on a digital set e.d. switching from non provisioned to provisioned is not a big task but read the installation manual for DECT R4

[ul]
[li]B = Barred
A B is shown on your phone's display when the system administrator has set you to outgoing call barred status. You will only be able to make internal calls while this is applied.[/li]
[li]D = Diverting (Forwarding) Calls
A D is shown on your phone's display when you have forward unconditional enabled.[/li]
[li]G = Group Member (In Group)
A G is shown on your phone's display when have been configured as a member of a hunt group and your membership is enabled. While this is the case, you may receive calls targeted to the hunt group.[/li]
[li]N = No Calls (Do Not Disturb)
An N is shown on your phone's display when you have do not disturb enabled.[/li]
[li]O = Out of Service
An O is shown on your phone's display when any of the groups of which you are enabled as a member is set to night service mode. In that mode calls to that group are diverted to its fallback if set or otherwise to voicemail if available.[/li]
[li]T = Twinned
A T is shown on a phone's display if it is internally twinned with your phone. Calls to you will alert on both phones and can be answered by you at either phone.[/li]
[li]S = System Alarm
If you are configured as a system administrator, an S in the phone's display indicates a system alarm.[/li]
[/ul]