Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

3300ICP MXE Dual Framer Issue

Status
Not open for further replies.

rdpayne

IS-IT--Management
Joined
Jun 20, 2006
Messages
80
Location
US
I've got two MXE's setup in our lab for a customer install. Everything has been going well, and we've finished programming up the PRi cards on both systems. I've got a loopback adapter on all the PRI and T1 ports to clear the NETSYNC alarms. On Site 2, we have not continuing alarms on the VDSU, but on Site 1, I am getting the following:

VDSU-9 - TUE SEP 26 14:12:17 2006 MTALARMS -- decoded alert report from UAPI.

VDSU-9 - TUE SEP 26 14:12:17 2006 MTALARMS -- received alert from PCAPP, count=1.

VDSU-9 - TUE SEP 26 14:12:17 2006 MTALARMS -- link #=0, cat.=256, sev.=0, state=0, upd.=1, inf. 2k=1.

VDSU-9 - TUE SEP 26 14:12:17 2006 MTALARMS -- Alert_Dchannel_Failure now Active.

VDSU-9 - TUE SEP 26 14:12:17 2006 MTALARMS -- received alert report from PCAPP for link 0, count=1.

VDSU-9 - TUE SEP 26 14:12:17 2006 MTALARMS -- change state check: prev=0; current=0.

I've gone through the EDT maintenance commands, but I'm honestly not sure from what I am seeing here exactly what I am looking for. Any ideas? Thanks.
 
This isn't an MSDN T1 is it? MSDN cannot be put in hard loopback.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top