2948G-L3

[efector]

I currently have 2 physical networks. 10.10.100.0 & 10.10.200.0. The .100.0 network is on the 2948G-L3. The networks arent able to connect to each other since there is no router to do so. Is it possible to assign a port(with a .200.0 address) on the switch to route between the two networks? If so, how? The only thing i want to do is to have any traffic destined for .100.0 from 200.0 to go thru the switch, otherwise i want all other traffic to go thru the gateway to the internet, and the same thing applies to traffic .200.0 from .100.0. Its a PITA to have these two networks and I cant get to them from either side.

Thanks in advance!

 

[computerhighguy]

You will need to add an IP address from both Subnets to the router. This is pretty easy.

go to the switch and do sommething like this.

Interface vlan 1
ip address 10.10.100.1 255.255.255.0
ip address 10.10.200.1 255.255.255.0 secondary

Add the routes to your default gateway so that it will know how to route the subnets.


It is what it is!!
__________________________________
A+, Net+, I-Net+, Certified Web Master, MCP, MCSA, MCSE, CCNA, CCDA, and few others (I got bored one day)