2620 and a WIC-1ENET card 12.3(13a)

[br0ck]

Ok let me start with I know less than nothing about cisco routers!
And I’m trying to learn…

I got my hands on a 2620 and a WIC-1ENET card


The card requires:

WIC-1ENET Software Requirements 
The WIC-1ENET card requires Cisco IOS Release 12.2(2)XJ or later if the card is installed in any WIC slot other than slot 0 or if more than one card is installed. 
The card can be used with Cisco IOS Release 12.2(4)T, but the card must be installed in slot 0 and only one WIC-1ENET card can be installed in the router.
 
[URL unfurl="true"]http://cisco.com/en/US/products/hw/modules/ps2641/products_installation_guide_chapter09186a008007cb78.html[/URL]

So I upgraded the router to Version 12.3(13a)
I also have only one card in WIC0

When I boot the router I get one quick blink on the link light of the WIC-1ENET card
And the following message:

Smart Init is enabled
smart init is sizing iomem
  ID            MEMORY_REQ                 TYPE
000094          0X000B3B80 C2600 Single Fast Ethernet
                0X00098670 public buffer pools
                0X00211000 public particle pools
TOTAL:          0X0035D1F0

If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 4Mb.
Using 12 percent iomem. [4Mb/32Mb]

Excuse my lack of knowledge but this looks like it is low on system memory?!
What else am I missing?

I don’t get the second interface and I get no link lights on the card

I want to get this going with 2 interfaces so I can start moving traffic
I also don’t have anymore money to put into this
Help Pls TIA

Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.3(13a), RELEASE SOFTWARE (fc2)
Technical Support: [URL unfurl="true"]http://www.cisco.com/techsupport[/URL]
Copyright (c) 1986-2005 by cisco Systems, Inc.
Image text-base: 0x80008098, data-base: 0x80CD3620

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-I-M), Version 12.3(13a), RELEASE SOFTWARE (fc2)
Router uptime is 2 minutes
System returned to ROM by power-on
System image file is "flash:c2600-i-mz.123-13a.bin"
cisco 2620 (MPC860) processor (revision 0x102) with 28672K/4096K bytes of memory
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102

 

[JOAMON]

I do not think that card is compatible with that router. Think you need a fast ethernet network module for it.

 

[webnetwiz]

WIC-1ENET is designed only for 1700 series routers, and is not compatible with any other router. for your 2600, you'll need either a nm-4e, or nm-1fe-tx (not sure if nm-1fe-tx is supported, check Cisco's site.)