2610 and VLANS

[BobW333]

I'm trying to configure VLANS on a 2610 with no avail.

What O/S version and how much memory should I have to support this?

 

[BobW333]

Here's a sh ver of the router to show whats running at present.


sh ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.3(5e), RELEASE SOFTWARE (fc2)
Technical Support:

http://www.cisco.com/techsupport

Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Mon 25-Apr-05 18:55 by ssearch
Image text-base: 0x80008098, data-base: 0x80CA6860

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-I-M), Version 12.3(5e), RELEASE SOFTWARE (fc2)

Earlston_H/S_VLAN_Cont uptime is 44 minutes
System returned to ROM by power-on
System image file is "flash:c2600-i-mz.123-5e.bin"

cisco 2610 (MPC860) processor (revision 0x202) with 28672K/4096K bytes of memory
.
Processor board ID JAD04010G3Q (3687456246)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
Basic Rate ISDN software, Version 1.1.
1 Ethernet/IEEE 802.3 interface(s)
4 ISDN Basic Rate interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

Bob

 

[BobW333]

OK after much digging on Cisco's web site I think I need
c2600-is-mz.12.2-11.yt2 IOS but it can't be located on the site.

Can anyone help with either a suitable alternative or a copy of it?

 

[JOAMON]

Why not just use the latest 12.2
c2600-is-mz.122-31.bin

Same feature set...newer release.
Need 48 and 16 memory.

 

[BobW333]

That would be 2 easy and you may have missed that I don't have enough memory for it.

 

[ADB100]

I thought you needed a Fast Ethernet interface to do VLAN trunking on 2600 routers? I remember looking into this a while ago and Cisco came back with that answer. Apparently any IP Plus or above image will do it but only with Fast Ethernet interfaces.
I seem to recall that it WAS possible on 10Mb Ethernet interfaces in a particular IOS but never found the exact info.

HTH

Andy

 

[BobW333]

Thanks for this Andy, the cisco system gave me the IOS mentioned above as being the one to use for the hardware that I have BUT, I can't find a copy of the IOS.

TYPICAL!

Bob